![]() ![]() ![]() You can also see a couple of my mods in this pic - I extended the rear vise jaw to get it closer to the blade allowing smaller pieces to be clamped closer to the blade. I did a quick check of my pics and found this one of a simple method of helping align the blade to the bed of the saw (critical for a straight cut) The two 3 bearing guides will have a little bit of slack/looseness in them to allow aligning of the blade with a square - the little piece of metal clamped to the blade gives more area for the square to align with and allowing easier adjusting. The saw does probably need a check for alignment - do get over to the yahoo group and check in - along with alignment tips there are lots of mods that are well worth doing. The blades origin/condition is an unknown to you, plan on replacing it soon with a bi-metal in something like a 10-14tpi (thats a pretty good general purpose tpi for the home shop)Īluminum can be problematic - it can want to 'clog' the blade teeth and cause binding (back to condition of blade?) Probably more than one factor involved here with the binding. First - that buy just about rates a gloat - good score, youre gonna love that thing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |